Printed a sample battery terminal cover today. The video below shows the start of the print. I have to print it upside down so the print doesn't fall in on itself, so the video is showing the top of the cover and it will work its way up layer by layer to the bottom of the battery cap.
----
The photo below shows the start of the print after just one layer.
The finished print flipped over the right way up, fresh off the printer.
The battery terminals before the cover was fitted.
The battery terminals with the new cover trial fitted. I found it was too narrow and too tall, and the large circular cups that push onto the big nuts were too tight. So I shall tweak the design and try again.
No comments:
Post a Comment